We stock a wide variety of electrical tools and equipment including plugs, adapters, sockets, testers, generators, chargers, batteries etc. Some of our product highlights are described below.
Digital Pocket Multi Meter T7290
- Pocket size hand held digital multi meter.
- It has many features including AC/DC voltage.
- DC current and resistance measurements.
- Low cost
- Integral leads
- Continuity
- Low power consumption
Time Switch
- A plug in “timer” which allows electrical appliances, lights, TV’s
to be programmed to switch on and off as required - Digital —integrated circuit.
- Large LCD display
- Easy to use multi functions..
- Heavy loading capacity.
Battery Charger –POWER 10
The unit has been especially designed for the discerning farmer; caravaner, power/ski boater and householder who requires a reliable and robust battery charger. A high reactance transformer which both limits the maximum charging rate and provides a good taper charge was designed for this
charger. This allows for hands “hands off” operation.
- Complies with SABS IEC 335-2-29
- Thermal overload protection
- Automatic circuit breaker protection
- Easy to follow instructions
- Robust, epoxy coated steel cabinet
- Two year warranty
Inverter –QUASI Sine Wave
- Quasi-sine wave inverter converts low voltage 12v DC from battery to 230v AC output similar to that supplied by the mains.
- Can be used to operate a variety of electrical appliances up to the rating of the inverter (300W).
- Output frequency 50/60 Hz (± 2%).
Soldering Gun—Electric
- An industrial gun with high-insulated Bakelite housing and built- in copper coil and instant heat.
- The gun has a three second warm up time, trigger switch and workpiece illumination light.
- Complete with two tips and coil of multi-purpose solder.
- SABS approved.
Lambda Sensor Tester
- Checks for correct Lambda switch operation on fuel injection
or engine management systems. Can be used to perform a
loaded test whilst driving the vehicle. Use in conjunction
with a gas analyser to help establish correct ECU operation. - Simple, 2 wire connection with easy to understand LED
indicators - Lightweight unit with 2 m leads for easy access to difficult to
reach sensors - Crocodile type earth clip and insulation piercing signal probe
for fast, easy connection
Ignition Module Tester
- This multi purpose tool is used for testing electronic ignition systems.
- Tests electronic ignition modules in situ, under load and
through rpm range. - Tests ignition switch signal outputs from hall effect and
reluctor sensors. - Tests ignition coils in situ.
- No internal battery, uses vehicle’s own 12 v dc battery
- Comprehensive kit with range of cable connections and
instruction guide.